About storage drawer and cover removal. GEAppliances.com
Not all features are on all models.
Humidity Controlled Drawer (on some models)
Slide the control all the way to the Slide the control all the way to the LOW
HIGH setting to provide high humidity setting to provide lower humidity levels
recommended for most vegetables, recommended for most fruits.
Drawer Removal
Drawers can be removed easily by grasping
the sides and lifting up slightly while pulling
drawers past the stop location.
!_iiiI iiiii/__ilil i_
Cover Removal
To remove:
r_ Remove the drawers.
r_ Reach in, push the back of glass cover up,
and at the same time, pull it backward as
far as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass cover with hot water because the extreme
temperature difference may cause it to break.
r_ Remove the drawer frame. (Always remove
the glass cover before you take out the
d rawer fra me.)
Lift the frame off the supports at each side and
back, pull it forward, tilt it and take it out.
To replace:
r_ Lower the frame until it rests on the
supports at each side and back.
r_ Replace the glass cover, pushing its front
edge firmly into the front frame channel
and gently lowering the back into place.
r_ Replace the drawers.
About the automatic ice maker
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Power Switch
Avoid contact with the
moving parts of the ejector mechanism, or
with the heating element (located on the
bottom of the ice maker) that releases the
cubes. Do not place fingers or hands on the
automatic ice making mechanism while the
refrigerator is plugged in.
Automatic Ice maker (on some models).
The ice maker will produce approximately
70-100 cubes in a 24-hour period, depending
on the freezer compartment temperature, room
temperature, number of door openings and other
use conditions.
If the refrigerator is operated before the water
connection ismade to the ice maker, set the
switch OFF.
When the refrigerator has been connected to the
water supply, set the switch ON position.
The ice maker will fill with water when it cools to
15°F. A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes.
Once the ice maker starts to make ice, it may take
up to 48 hours to fill the bin, depending on the
temperature settings and number of door openings.
You will hear a buzzing sound each time the ice
maker fills with water.
NOTICE: Throw away the first few batches of ice
to allow the water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
When the bin fills to the level of the feeler arm, the
ice maker will stop producing ice.
It is normal for several cubes to bejoined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, shrink or fuse together.
Ice maker accessory kit:
If your refrigerator did not already come equipped
with an automatic ice maker, an ice maker
accessory kit is available at extra cost.
Check the back of the refrigerator for the specific
ice maker kit needed for your model.
To Next Page
Loading...
Need help?
General
