– 8 –
PUSH UP ON
VENT LIP
LOWER PANEL
INTO PLACE
SPARK MODULE
The spark module is located behind th
control panel, on the right side. You mus
remove the control panel to access th
spark module.
EINSTALLING CONTROL PANEL
hen reinstalling the control panel, push
p on the vent lip with your fingers. At the
ame time pull forward on the control
anel, making sure that the vent lip is
UCKED UNDER the control panel while
owering the panel into place.
SPARK
MODULE
BALLAST
TABS
TUCK VENT LIP UNDER CONTROL
PANEL PRIOR TO LOWER PANEL
GEA00127
REINSTALLING CONTROL PANEL
When reinstalling the control panel, push up
on the vent lip with your fingers. At the same
time, pull forward on the control panel,
making sure that the vent lip is tucked under
the control panel while lowering the panel
into place.
SPARK MODULE
The spark module is located behind the control panel on
the right side. You must remove the control panel to
access the spark module.
To Next Page
Loading...
