– 4 –
Cooktop Removal
1. Remove electrical power to the range. Turn off gas at
the main valve.
2. Lift off burner grates, caps, and burner heads.
3. Remove 8 screws holding burner bases to cooktop.
4. Lift bases and graphite seals off cooktop.
5. To release cooktop, disengage front clips (A) using a
flat blade screwdriver.
6. Gently raise the top high enough for the prop rods to
hold it upright.
NOTE: When the cooktop is raised, the gas jets and
warming zone unit are accessible for repair.
7. Remove 4 wires (B) connected to the warming zone.
8. Disengage the prop rods from the range side panel.
Lift off the cooktop.
9. When reinstalling burner heads, make sure the nipple
in the burner head is positioned toward the electrode.
Rotate the burner head around the burner base until
it is level and securely seated.
Grate
Burner head
Burner cap
Electrode
Burner base
GEA0012
GEA00134
Venturi
Assembly
Glass
Cooktop
urner
ase
Burner
Head
Burner
Cap
Fiber Gask
Graphite Seal
GEA0012
B
A
A
To Next Page
Loading...
