GE JGB910 - Using the Oven Temperature Probe

Usingthe probe.(onsome models) www.GEApplia,ces.com
For many foods, especially roasts and poultry, internal food temperature is the best test for doneness. Thetemperature
probe takes the guesswork out of roasting by cooking foods to the exact aloneness you want.
Use of probes other than the one pr(wided
with this product may result in damage to
the probe.
Use the handles of the probe and plug
when inserting and removing them fl'om
the fi)od and outlet,
Cable
Plug
Pmh_
"and,e:
Thetemperature probe has a
skewer-like probe at one end and a
plug at the other end that goes into
the outlet in the oven.
Toavoiddamagingyourprobe,donotusetongs
topuffonthecablewhenremovingiL
_,Toavoidbreakingtheprobe,makesurefoodis
completelydefrostedbeforeinsembg.
Topreventpossib/e burns,do not unplug the
probe from the outlet until the oven hascooled
Neverleaveyourprobeinsidetheovenduring
aself-cleaningcycle.
Do not store theprobe in the oven.
_Mter preparing the meat and placing it on
a trivet or on the broiler pan grid, tollow
these directions fin" proper probe
placement.
Insert the probe completely into the meat.
It should not touch the bone, ti_t or gristle.
For roasts Mth no bone, insert the probe
into the meatiest part of the roast. For
bone-in ham or lamb, insert the probe into
the center of the lowest large muscle.
Insert the probe into the center of dishes
Stlch as Illeat loat or casseroles.
Insert the probe into the meatiest part of
the inner thigh fl'om below and parallel to
the leg of a whole turkey:
How to Set the Oven For Roasting When Using the Probe
[] Insert the probe into the food. ] _q_en the internal temperature of the
food reaches the number you have set,
[] Plug the probe into the outlet in the
oxen. Make sure it's pushed all the
way in. Close the oxen (loo_:
[] Touch the PROBE pad.
[] Touch the number pads to set the
desired internal fi)od or meat
temperature.
[] Touch the BAKEpad.
[] Touch the number pads to set the
desired oxen temperature.
[] Touch the START pad.
Thedisplay will flash if theprobe is insertedinto the
outlet and youhave not set a probe temperatureand
touchedthe STARTpad
_Mier the internal temperature of the fi)od
reaches 100°E, the changing internal
temperature will be shown in the display.
the probe and the oven mrn off and
the oven control signals. To stop the
signal, touch the CLEAR/OFFpad. Use
hot pads to remove the probe fl'om
the food. Do not tlse tongs to pull on
it--they might damage it.
To change the oven temperature during
the Roast cycle, touch the BAKE pad and
then the number pads to set the new
temperature.
:_ff theprobe is removedfrom the food before the
final temperatureis reached,a tone will sound
and the displaywill flash until theprobe is
removed from the oven.
Youcan use the t/_nereven though you cannot
use timed oven operations while using the
probe.
2/