The oven doormust be closedand all controlsset correctly for the cycle towork properly.
How to Delay the Start of Cleaning
Make sure the clock shows the correct
time of day.
[] Touch the SEI.FCIBINpad.
[] Using the number pads, enter the
desired dean time.
[] Touch the DEI.AY$TARTpad. The
earliest start time you can set will
appear in the display.
[] Using the number pads, enter the
time of day you want the clean cycle
tOst31"L
[] Touch the STARTpad,
The door locks automatically. The
display will show the start time. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKEDDOOR
light goes off.
When the LOCKEDDOORlight is off, open
the door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up witha damp cloth after
the oven cools.
ffwhitespotsremain,removethemwithasoap-
filledsteel-wealpadandrinsethoroughlywitha
vinegarandwatermixture.
These deposits are usually a salt residue
that cannot be removed by the clean cyde.
If the oven isnot clean after one clean
cycle, repeat the cycle.
• You cannot set the oven for cooking
until the oven is cool enough for the
door to unlock.
• While the oven is serf<leaning, you
can touch the CLOCKpad to display
the time of day. To return to the
dean countdown, touch the COOKING
TIMEpad.
• If the shelves become hard to slide,
apply a small amount of vegetable oil or
cooking oil to a paper towel and wipe
the edges of the oven shelves with the
paper towel.
31
To Next Page
Loading...
