Sealed Burner Assemblies--glass cooktop models
Turn all controls 0Be before removing the
burner parts.
The burner grates, caps, and burner heads
can be lifted off, making them easy to clean.
_ Electrode
/
When one burner is turned to
all the burners spark. Do not attempt
to disassemble or clean around any
burner while another burner is on. An
electric shock may result, which could
cause you to knock over hot cookware.
A CAUTION:Donotoperatethe
burnerwithoutall burnerpartsin
place.
After cleaning,makesurethe
nippleinthe burnerheadis
positionedtowardthe electrode.
Rotatethe burnerheadaroundthe
burnerbaseuntilit is level and
securelyseated
Burner Heads
NOTE:Beforemmevingtheburnerbeadsand
caps,remembertheirsizeandlocation.Replace
theminthesame/ocatieaaftercleaning.
Theslitsintheburnerheadsofyourrangemustbe
keptcleanatafttimesforaneven,unhampered
flame.
You should dean the surface burners
routinely, especially after bad spillovers,
which could clog these openings.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20-30 minutes.
For more stubborn stains, use a toothbrush.
Before putting the burner head back, shake
out excess water and then dry it thoroughly
by setting it in awarm oven for 30 minutes.
Replace the burner heads and caps. Make
sure that the heads and caps are replaced in
the correct location. There are 2 large, one
medium and one small head and cap.
Burner Caps
Lift offwhen cool. Wash burner caps hi hot,
soapy water and rinse with clean water. You
may scour with a plasdc scouring pad to
remove burned-on food particles.
Dry them in a warm oven or with a doth-
don't reassemble them wet. Replace the
burner caps.
Make sure that caps are replaced on the
correct size burner. There are 2 large, one
medium and one small head and cap.
33
To Next Page
Loading...
