Installation of therange.
Readthese insttuctioescompletelyandcarefully.
[] Adjust Broil and Oven Burner Air Adjustment Shutters ff Necessary
Airadjus_nontshuttersforthetopandbottomburners
regulatetheflowofairtotheflames.
shutter
The air adjustment shutter for the top (broil)
burner is in the center of the rear wall of the oven.
The shutter for the bottom (oven) burner is near
the back wall behind the warming drawer. Remove
the drawer. See the Care and cleaningof the range
section.
Toadjusttheflowofairtoeiderburner,loosenthePhillips
headscrewandrotatetheshuttertowardopenorclosed
positionasneadad
To determine if the bottom burner flames are
burning properly, remove the oven bottom. Flames
should have approximately 1=blue cones and, if
range is supplied with natural gas, should burn with
no yellow tipping. (With most LP gas, small yellow
tips at the end of outer cones are normal.) Flames
should not lift offbumer ports. Ifliftingis obsexved,
gradually reduce air shutter opening until flames
are stabilized.
Toremove the ovenbmWnr
[] Remove the knurled screws holding down
rear of the oven bottom.
[] Grasp the oven bottom at finger slots on
each side.
[] Lift the rear of the oven bottom enough to
clear the lip of the range frame, push it back,
and then pull it up and out.
The flames for the top (broil) burner should be
teady ruth approxtmately I blue cones and should
not extend out over the edges of the burner baffle.
5O
[] Leveling the Range
[] Remove the warming drawer. See the Care and
cleaning of the range section.
[] Usea3/16" open-end or
socket wrench to back
out both rear leveling
legs approximately 2
tUlTIS.
[] Use a 1%"open-end or
adjustable wrench to
back out the front
leveling legs two turns.
[]
[]
Install the oven shelves in the oven and
position the range where it will be installed.
Check for levelness by placing a spirit level or a
cup, partially filled with water, on one of the
oven shelves. If using a spirit level, take two
readings--with the level placed diagonally first
in one direction and then the other.
[] Adjust the leveling legs undl the range is level.
[] After the range is level, slide the range away
from the wall so that the Anti-Tip device
can be installed.
To Next Page
Loading...
