Before YouCall ForService...
_ Troubleshooting tips
Possible Causes What ToDo
_1_;, Light bt_ is lease or defective. • Tighten or replace the bulb.
Plug on range is not completely • Make sure electrical plug is plugged rote a lwe, properly
inserted in the electrical outlet, grounded outlet.
llt_q _.ll_dee_'_,- The _ tempea-ature is too • Allow the range to cool to room temperature and
high to set a self-clean operation, reset the controls.
Oven controls improperly set. • See the Using_e seif-cloanmgovensection.
"4_qtlfll_,_'mOir This is the sound of the • This is normal.
"_" _. metal heating and cooling
during both the cooking and
cleaning functions.
r r
Im_t_, Excessive soil. • Touch the CLEAR/OFFpad Open the windows to
rid the room of smoke. Wait until the LOCKEDDOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
atO_ tt¢//,eet _0u. Oven too hot. • Allow the oven to cool below locking temperature
strutau/ m q,ao
Omep_ MIwa Oven controls not propedy set. " Seethe Us#ngthesoff-cloanmgovensection.
¢/e_ ¢lade
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heawly soiled ovens may need to self-clean
again or for a longer pelaod of time.
_llt_h_ . The serf.clean cycle has been • Close the oven door.
in the di_/_ selected but the door is not
dosed.
/O_tl]l_ 00_1_ H_ The oven door is locked • Touch the C/.BIP,/O,L"Fpad. Allow the oven to cool.
off_lmm _ because the temperature
_t ¢d_k inside the oven has not
dropped below the
locking temperature.
qg--a_e_at r You have a functinn error code. • Touch the CLFMlR/OB:pad.Anowtheoventocoolfor
hffma_mh im _ _l t one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the funcdon error
code repeats, call for servtce.
_',_o_wtttra im This is reaninding you to enter a • Enter a probe temperature.
_€/_ probe temperaUae after plugging
in the probe.
54
To Next Page
Loading...
