Installation Instructions
USAGE SITUATIONS WHERE
APPLIANCE POWER CORD
WILL BE DISCONNECTED
INFREQUENTLY
For 15 amp circuit only. Do not use an adaptor
on a 20 amp circuit. Where local codes permit, a
TEHPORARY CONNECTION may be made to a properly
grounded 2-prong wall receptacle by the use of o
UL-listed adaptor available ot most hardware stores.
The larger slot in the adaptor must be aligned with
the large slot in the wall receptacle to provide proper
polarity in the connection of the power cord.
Ensure proper ground and firm
connection before use
Align Iorge
prongs/slots
Temporary Method
(Adoptor plugs not permitted in Conodo)
A r'All_l,,_LI
AIIkL,/_LI/IUI_I: Attoching the odoptor ground
terminol to the woll receptocle cover screw does not
ground the opplionce unless the screw is metal, ond
not insuloted, ond the woll receptocle is grounded
through the house wiring. The customer should hove
the circuit checked by o quolified electricion to make
sure the receptacle is properly grounded.
When disconnecting the power cord from the
adaptor, always hold the adaptor with one hand. If
this is not done, the adaptor ground terminal is very
likely to break with repeated use. Should this happen,
DO NOT USE the appliance until a proper ground has
again been established.
Usage situation where appliance power cord will be
disconnected frequently.
Do not use on odoptor plug in these situotions
because disconnection of the power cord places
undue stroin on the odoptor ond leods to eventuol
foilure of the odoptor ground terminol. The customer
should hove the 2-prong receptocle reploced with
o 3-prong (grounding) receptocle by o quolified
electricion before using the opplionce.
To Next Page
Loading...
Need help?
General
