Usingthe self-cleaning oven. gecom
The oven door must be closed and all controls set correctly for the cycle to work properly.
_o @ o
Wipeupheavysoilontheoven
bottom.
Before a Clean Cycle
For the first self clean cycle, we recommend
venting your ldtchen with an open window
or using a ventilation tim or hood.
Remove shelves, any broiler pan, broiler
grid, all cool<ware and any aluminum fbil
fiom the oven°
The shiny, silve>colored oven shelves
(on some models) can be selfk-.leaned,
but they will darken, lose their lusmr
and become hard to slide°
Soil on die flop.t flame of the oven and
outside the gasket on the door will need to
be cleaned by hand° Clean these areas with
hot wam_; soal>filled scrubbing pads or
cleansers such as Soft: Scrub °. Rinse well
with clean wa.mr and dry.
Do not clean the g_Lsket.The fiberglass
mamfia/of the oven door gasket cannot
withstand abrasion. It is essendN for the
gasket to remain intact. If you notice it
becoming worn or flayed, replace it.
Wipe up any hem T spillovers on the
oven bottom.
Make sure rite oven light bulb cover is
in place and the oven light is off
IMPORTANT: The health of some birds is
extremely sensitive to the flmles given off
dming the self cleaning cycle of any oven.
Move birds to another welbvenfilamd room.
How to Set the Oven for Cleaning
[_] Touch the SELFCLEAN pad.
_] Touch the ÷ or-pad to enter the
desired clean time, if a time other
than 4 ]tours is needed.
Clean cycle dine is nommUy 4 hom_.
You can change the clean time to any time
between 3 hom_ and 5 hours, depending
on how dirty your oven is.
[_ Touch the STARTpad.
The door locks automatically: The display
will show tlle clean dine remaining. It will
not be possible to open the oven door
undl the mmpemmre drops below the
lock temperature and the LOCKEDDOOR
light goes ofIi
When the LOCKEDDOORlight is off, open
the door
The oven shuts off automatically when file
clean cycle is complem.
NOTES:
The words LOCKD00R will flash and the
oven control will signal if you set the
clean cycle and fbrget to close the oven
dooi:
To stop a clean cycle, touch the
CLEAR/OFFpad. %qlen the LOCKEDDOOR
light goes off indicating the oven has
cooled below the locking mmpemmre,
open the door
How to Belay the Start of Cleaning
Delay Start is setting the oven to start the
clean cycle automatically at a later time
than the present time of day.
NOTE:Before beginning, make sure the
oven clock shows the correct time of day.
[_] Touch the SELFCLEAN pad.
[_ Touch the + or-pad to enter the
desired clean time.
%
Touch the OELAYSTART pad. The
earliest start time you can set will
appear in the display.
[_] Touch the + or-pad to enter the time
of day you want the clean cycle to start.
[_ Touch the START pad.
The door locks automatically. The
display will show the start time. It will not
be possible to open the oven door until
the mmpemmre drops below the lock
temperature and the LOCKEDDOORlight
goes oft
When the LOCKEDDOOR light is off; open
the door
NOTE.
You can find out when the clean cycle
will start by touching the DELAYSTART
pad.
25
To Next Page
Loading...
