Beforeyoucall forservice...
Troubleshooting 77ps
Possible Causes What ToBe
Oven light does not work Light bulb is loose or defective. * Tighten or replace the bulb.
The pad operating the oven light * Ca/1 for service.
is broken.
Oven wiiinotself-clean The oven temperature is too * Allow tile oven to coo| to room temperature and
high to set a self-clean operation, reset file contro|s.
The oven door is not fully closed. * Close dooc
Oven controls improperly set. * See the Using the self-cleaning oven section.
"Crackling" or This is the sound of the * This is hernia/.
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil.
* Touch tlle CLEAR/OFF pad. Open tile windows to
rid the roonl of smoke. Wait until tile LOCKEDBOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door willnot open Oven too hot. * Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven controls improperly set. * See tile Using the self-cleaning oven section.
clean cycle
Oven was heavily soiled. * Clean tip heavy spillovers bef(ne starting tile clean
cycle. Heavily soiled ovens may need to self'clean
again or for a longer period of dine.
"LOCKBOOR" flashes The self-clean cycle has been * Close tile oven door.
inthe display selected but the door is not
closed.
LOCKEDDOORlight The oven door is locked * Touch tile CLEAR/OFF pad. Allow tile oven to cool.
flashes in the display because the temperature
inside the oven has not
dropped below the
locking temperature.
"F--and a numberOr
letter" flashin thedisplay
You have a function error code. * Touch tile CLEAR/OFF pad. Allow file oven to cool fbr
()lie houi; Put the (well back into opeiafion.
Function error code repeats. * Disconnect all power to tile oven for 5 minutes
and then reconnect power. If the flnlcfion error
code continues repeating, call for service.
?2
To Next Page
Loading...
