1
TOOLS YOU WILL NEED
Safety Glasses
Cut Resistant Gloves
“If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com”
PARTS INCLUDED
(3) ¼” drive #8 x 3/4”
Sheet Metal Screws
T10 TORX
®
Bit
Island Trim
31-10953 02-14 GE
Installation
Instructions
Gas Slide-in Range
Island Installation Kit
In order to install the island trim kit, you must first
remove the two (2) short trim pieces on both sides.
1. Remove (3) three T10 TORX
®
screws.
2. Remove (1) one ¼” sheet metal screw retaining
the rear trim and discard.
NOTE: When the screws are removed from the
rear trim it may flex away from the back of the
range – this is normal.
3. Remove short trim.
4. Repeat steps 1 thru 3 on the opposite corner.
Nutdriver
Side Trim
Short Trim
Rear Trim
Sheet Metal
Screw
T10 TORX
®
Screws
To Next Page
Need help?
General
