Before YouCallForService...
Troubleshoo_ng-tips
Possible Causes
You have a function
error code.
If the function
code repeats.
A fuse in your home may
be blown or the circuit
breaker tripped. -
The clock is in the
black-out mode.
What ToDo
• Press the CLEAR/OFFpad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
Power failure. • Reset the clock.
Oven control pads were
not pressed properly.
• The BAKE and BROILHI/LO pads must be pressed
at the same dine and held for 3 seconds.
Power outage or surge.
This is normal in a
new oven and will
disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
A cooling fan may
automatically turn
on and off.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CI.E4R/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
]eThis is temporary.
• This is normal. The cooling fan will turn offand on
to cool internal parts. It may run after the oven is
turned OFF.
24
To Next Page
Loading...
Need help?
General
