GE JKP27 User Manual

Usingthe clock and timer.
Make sure flTeclock is set to the
correct time of da_
ToSet the Clock
The (h)(k must be setu) the tone( t time
of day for tile autolIlatic oven tilIling
fln_ctions to work properly. The time of
day ( anno[ be changed during a flirted
baking or self-cleaning Q,cle.
[] Press tile CLOCKpad.
[] Press tlle HOURand MIN + or
- pads to set tile time of'(kff.
[] Press tile STARTpad.
[ TIMER
Ttie timer is a minute timer onl_
Ttie timer does not control oven
operations. Ttie maximum setting on
ttie timer is 9hours and 59 mhTutes.
To Set the Timer
[] Presstile KITCHENTIMER
ON/OFFpad.
[] Press tlle HOURand MIN+ or
- pads until tile amount of time
you want shows in the display.
If you make a mistake, press
KITCHENTIMERON/OFFand begin
again.
[] Press the STARTpad.
Atier pressing the STARTpad, SETdisappears,
this tells you the tlYneis counting down, although
the displaydoes not changeuntil one minute
haspassed
[] When the timer reaches :OO,the
control will beep 3 times fi)llowed
by one beep eveU 6 seconds until
the KITCHENTIMERON/OFFpad
is pressed.
The6secondtonecanbecanceledbyfollowIw
thestepsintheSpecialfeaturesof youroven
controlsectionunderTonesat theEndof a
timedCycle.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the KITCHENTIMERON/OFFpad, then
press the HOURand MIN ÷or - pads until
the time you want appears in the displ W.
If tile relnaining tilne is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHENTIMERON/OFFpad
and then pressing the HOURand MIN+
or - pads to enter the new time you want.
ToCancel the Timer
Presstim KITCHENTIMERON/OFF
pad tM(e.
72

GE JKP27 Specifications

General

Brand	GE
Model	JKP27
Category	Oven
Language	English