1
Built-In Wall Oven
Installation
Instructions
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT—Save these
instructions for local inspector’s use.
• IMPORTANT—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Tools Needed
1/8” (3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Materials Needed
Strain Relief Clamp
for 1/2” conduit
Junction
Box
Wire Nuts
36” (91 cm)
of String
31-10647 02-07 JR
Parts Included
(Appearance will vary)
Screws For Installation
(8-18 x .750 flat head
Phillips wood screws)
Optional 27″
(68.6 cm)
Metal Bottom
Trim Assembly
(on some models or
can be purchased
separately)
27” (68.6 cm) models
JKS10, JKP30, JKP35, JKP55, JKP70, JKP75,
PK916, PK956, ZEK938, ZEK958
30” (76.2 cm) models
JTP30, JTP35, JTP55, JTP70, JTP75, PT916,
PT920, PT956, PT960, ZET938, ZET958
30″ (76.2 cm)
Metal Bottom Trim
Assembly
27″ (68.6 cm)
Metal Bottom Trim
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
To Next Page
Need help?
General
