QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
“F- AND A
NUMBER” FLASH
IN THE DISPLAY
OVEN WILL
NOT WORK
OVEN LIGHT DOES
NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT OPEN
OVEN NOT CLEAN
A~ER
CLEAN CYCLE
“door” APPEARS
IN THE DISPLAY
“OFF” APPEARS
IN THE DISPLAY
OVEN TEMPERATURE
TOO HOT OR TOO COLD
“BURNING” OR “OILY”
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
FAN NOISE
POSSIBLE CAUSE
● This is the function error code. Press the CLEAWOFF pad. Allow oven to
cool
one hour. Place oven back into operation. If function error occurs again,
disconnect power to the oven and call for service.
● The circuit breaker in your house has been tripped, or a fuse has been blown.
Q
Oven controls not properly set.
● Light bulb is loose or defective. Tighten or replace.
● Pad operating oven light is broken. Call for service.
● The oven controls are not properly set. See the Broiling section.
● The door not left open to the broil-stop position as recommended.
“
Improper shelf position being used.
● Food is being cooked on a hot pan.
Q
Cookware is not suited for broiling.
● Low voltage. See the Broiling section.
● Aluminum foil used on the broiler pan rack has not been fitted properly
and slit as recommended.
● The oven controls are not properly set. See the Baking or Roasting section.
● Shelf position is not correct.
● Incorrect cookware of improper size is being used.
● The oven thermostat needs adjustment. See the Adjust the Oven
Thermostat–Do
Zr
Your.se~section.
● Temperature is too high to set self-clean operation. Allow the oven to cool, and
reset
tie
controls.
● Probe is in oven. Remove the probe.
● Oven must cool below locking temperature.
●
Oven controls not set properly. See the Operating the Self-Cleaning Oven section.
● Heavily soiled ovens require 3
Y2-
to 4-hour Clean Time.
● Heavy
spillovers
should be cleaned up before starting
clean
cycle.
● Oven door not closed after self-clean cycle selected.
● Door is still locked and You are trying to enter an oven cooking operation.
.-
—
● Oven is too hot for Self-Clean.
● Bake or Broil attempted too soon after Self-Clean.
● Other oven is in Self-Clean.
● Child Lockout feature turned on.
● The oven thermostat needs adjustment. See the Adjust the Oven
Thermostat-Do
Zr
Yourse~section.
● This is normal in a new oven and will disappear in time. To speed the process,
set a self-clean cycle for a minimum of 3 hours. See Operating the
Self-Cleaning Oven section.
● An odor from the insulation around the inside of the oven is normal for the first
few times the oven is used. This is temporary.
● A fan may automatically turn on and off to cool internal parts. This is normal
and the fan may continue to run even after the oven is turned off.
If
you need more help... call, toll free:
GE Answer
Center@
800.626.2000 consumer information service
30
To Next Page
Loading...
Need help?
General
