GE JP3036 - Element Control and Settings

12 49-80745-1
Tri-Ring Surface Element
Ŷ 7RXVHWKHODUJHVXUIDFHHOHPHQWSXVKDQGWXUQWKH
center control knob clockwise to
, stopping at the
desired setting. This will activate the entire heating area.
Ŷ 7RXVHWKHPHGLXPVXUIDFHHOHPHQWSXVKDQGWXUQ
the center control knob clockwise to , stopping at
the desired setting. This will activate the medium-size
heating area.
Ŷ 7RXVHWKHVPDOOHVWVXUIDFHHOHPHQWSXVKDQGWXUQ
the center control knob clockwise to , stopping at the
desired setting. This will activate the smallest, inside
heating area.
Element Cycling
Turn Product On/Off
Operating The Cooking Elements
USING THE COOKTOP:(OHPHQW&\FOLQJ7XUQ3URGXFW2Q2II2SHUDWLQJ7KH&RRNLQJ(OHPHQWV
Surface elements will cycle on and off to maintain the
temperature you have selected. All radiant surface elements
have a temperature limiter that protects the glass cooktop
from getting too hot, this is normal. The temperature limiter
may cycle the elements off more frequently if:
Ŷ 7KHSDQERLOVGU\
Ŷ 7KHSDQERWWRPLVQRWIODW
Ŷ 7KHSDQLVRIIFHQWHU
Ŷ 7KHUHLVQRSDQRQWKHHOHPHQW
Ŷ 3XVKWKHNQREGRZQDQGWXUQLQHLWKHUGLUHFWLRQWRWKH
setting you want. When the control is in any position
other than Off, it may be rotated without pushing it
down. You may feel a slight bump when it is rotated
through the Lo or Hi positions. You may hear slight
clicking sounds during cooking, indicating the control
is keeping the power level you set.
Ŷ $HOT SURFACE indicator light will glow when any
radiant element is turned on and will remain on until
the surface is cooled to approximately 150°F.
Ŷ %HVXUH\RXWXUQWKHFRQWURONQREWROff when you
finish cooking. It will snap into the Off position.
Dual Surface Element
Ŷ 7RXVHWKHVPDOOVXUIDFHHOHPHQWWXUQWKHFRQWURO
knob to the Small Burner settings.
Ŷ 7RXVHWKHODUJHVXUIDFHHOHPHQWWXUQWKHFRQWURO
knob to the Large Burner settings.