GE JP340 - Glass Cooktop Cleaning Procedures

Cleaningthe glass cooktop. . .GEA..liances.com
Clean your cooktop after
each spill. Use CERAMA
BRYTE® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLY use (:EILBd_JIABRYTE _'Ceranfic
Cooktop Cleaner on the glass cooktop.
Other creams may not be as eflbctixe.
To maintain and protect the smti_ce of
yore" glass cooktop, tollow these steps:
[] Befiwe using the cooktop for the
fi_t time, clean it with CEI_BdMA
BRYTE ':Ceramic Cooktop Cleane_:
This helps protect the top and
makes cleanup easier:
[] Daily use of (:EI_4A BRYTE _)
Ceramic (:ookt{}p Cleaner will help
kee I) the cooktop looking new.
[] Shake the cleaning creanl well.
Apply a few drops of CEILZ_dMA
BRYTE (':Ceramic Cooktop (:leaner
directly to the cooktop.
[] Use a paper towel or CEILQMA
BRVFE _>Cleaning Pad for Ceramic
Cooktops to clean the entire
cooktop S[lI'_ilce.
[] Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DONOT
heat the cooktop until it has been cleaned
thoroughlg
UseaCERAMABRYT£_Cleaning
Padfor CeramicCooktops.
Burned-On Residue
WARNING:DAMAGEtoyourglasssurface
mayoccurif youusescrubpadsotherthan
thoserecommended.
[] Allow the cooktop to cool.
[] Spread a f_'w drops ot CEIL_d_IA
BRYTE (_2'Cerallli{- Cookto I) Cleaner
on the entire burned residue area.
[]
Using the included CEI_Bd_IA
BRYTE <_:'Cleaning Pad flw Ceramic
Cooktops, Iub the residue area,
ali))lying,, pressure as needed.
[]
[]
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after
all residue has been remoxed,
polish the entire surtace with
CEI_Bd_4A BRYTE ':Ceramic
())oktop Cleaner and a paper towel.
&ii))(((;)7¸::
TheCERAMA BRYTE_ Ceramic
Cooktop Scraper and all
recommended supplies are
available llTrough our Parts Cente_
See flTstructions under "To Order
Parts" section on next page.
NOTE:Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
[] Allow the cooktop to cool.
[] Lrse a single-edge razor blade
scraper at approximately a 45 °
angle against the glass surtace
and scrape the soil. It will be
necessary to apply pressure to
the razor scraper in order to
remove the residue.
[]
After scraping with the razor
scrape_; spread a few drops of
CE/_Bd_IA BRYTE ) Ceramic
()}oktop Cleaner on the entire
burned residue area. Use the
(:EI_Bd_IA BRVFE ': Cleaning Pad to
remove any remaining residue.
[]
For additional protection,
after all residue has been
removed, polish the entire
surfilce with (;ER,Bd_IA BRYTE ')
Ceramic Cooktop Cleaner
and a paper towel.
11