Special Features of Your Oven Control
Control Lockout
Your control will allow you to lock down the touch
pads so they cannot be activated when pressed.
1. Press BAKE and BROIL HI/LO
at the same time for 2 seconds
until the display shows “SF.”
2. Press SELF CLEAN. The
display will show “LOC OFF.”
—Press SELF CLEAN again.
The display will show “LOC.”
3. Press START to activate the control
lockout feature and leave the control set
in this special features mode.
When this feature is on and the touch pads are pressed
the control will beep and the display will show “LOC.”
NOTE: The control lockout mode will not affect the
clock and timer touch pads.
START
SELF
CLEAN
BROIL
HI/LO
BAKE
Fahrenheit or Centigrade Temperature Selection
Your oven control is set to use the Fahrenheit
temperature selections but you may change this
to use the Centigrade selections.
1. Press BAKE and BROIL HI/LO
at the same time for 2 seconds
until the display shows “SF.”
2. Press BROIL HI/LO. The
display will show “F”
(Fahrenheit).
3. Press BROIL HI/LO again. The display
will show “C” (Centigrade).
4. Press START.
START
BROIL
HI/LO
BROIL
HI/LO
BROIL
HI/LO
BAKE
Changing the Speed of the + or – Pads
As you use the + or – pads when setting a time or
temperature, you may notice the display changes slowly.
This special feature allows you to change the speed.
To set the speed you prefer, follow the steps below.
1. Press BAKE and BROIL HI/LO
at the same time for 2 seconds
until the display shows “SF.”
2. Press the + pad. The display
will show you a set speed
between 1 and 5.
3. Press the + pad to increase the speed up
to the number 5.
—Press the – pad to decrease the speed down
to the number 1.
4. Press START to activate the setting
and leave the control set in this special
features mode.
START
BROIL
HI/LO
BAKE
To Next Page
Loading...
Need help?
General
