What to do if GE Ranges oven door will not open after a clean cycle?
If your GE Ranges oven door won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
What to do if my GE Ranges oven does not work?
If your GE Ranges oven isn't working, there are a few things to check. First, make sure that a fuse in your home hasn't blown or a circuit breaker hasn't tripped; if it has, replace the fuse or reset the circuit breaker. You can also check the oven controls. Also, verify that the oven is not in Sabbath Mode.
Why is there a strong odor when I use my GE Ranges?
An odor from the insulation around the inside of the oven is normal for the first few times the oven is used. This is temporary and will go away after several uses or a self-clean cycle.
What causes excessive smoking during the clean cycle on my GE JS760BL2TS Ranges?
If there is excessive smoking during the clean cycle of your GE Ranges, press the Cancel/Off pad and open the windows to rid the room of smoke. Wait until the LOCKED light goes off, then wipe up the excess soil and reset the clean cycle.
How to broil food properly in GE JS760BL2TS Ranges?
To broil food properly in your GE Ranges, ensure you select the appropriate broil mode and use the correct rack position. Make sure food is cooked in a cool pan specifically designed for broiling. If using aluminum foil on the broiling pan and grid, ensure it has been fitted properly and slit as recommended. In some areas the power (voltage) may be low, preheat the broil element for 10 minutes.
Why is there water remaining on oven floor after Steam Clean cycle of GE JS760BL2TS Ranges?
If you notice water remaining on the oven floor after the Steam Clean cycle in your GE Ranges, don't worry, this is normal. Remove any remaining water with a dry cloth or sponge.
Why is my GE JS760BL2TS Ranges making a 'clicking' noise when using my oven?
Your GE Ranges cycles the heating elements by turning relays on and off to maintain the oven temperature. This is normal.
How to fix GE JS760BL2TS oven light that does not work?
If the oven light in your GE Ranges isn't working, try these steps: first, check if the light bulb is loose or defective and tighten or replace it. Also, verify that the oven is not in Sabbath mode.
What to do if my GE JS760BL2TS Ranges oven is not clean after a clean cycle?
If your GE Ranges oven isn't clean after a clean cycle, it could be due to improperly set oven controls. See the Cleaning the Oven section for guidance. Alternatively, the oven may have been heavily soiled; clean up heavy spillovers before starting the clean cycle, and consider running the self-clean cycle again or for a longer period.
What to do if surface units on my GE JS760BL2TS Ranges do not work properly?
If the surface units on your GE Ranges aren't working, first check your home's fuse box or circuit breaker and replace the fuse or reset the breaker if needed. Also, ensure the cooktop controls are correctly set for the specific surface unit you're trying to use.
General| Brand | GE |
|---|---|
| Model | JS760BL2TS |
| Type | Slide-In |
| Fuel Type | Electric |
| Cooktop Surface | Ceramic Glass |
| Number of Burners | 5 |
| Oven Capacity | 5.3 cu. ft. |
| Self-Cleaning | Yes |
| Wi-Fi Connect | Yes |
| Convection | Yes |
| Width | 30 in. |
To Next Page
