Why GE JS760BL2TS signals after entering cooking time or start time?
If your GE Ranges signals after entering a cooking time or start time, it means you forgot to enter a bake temperature or cleaning time. Touch the Bake pad and desired temperature, or the Self Clean pad and desired clean time.
What to do if GE Ranges oven door will not open after a clean cycle?
If your GE Ranges oven door won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
What to do if surface units on my GE JS760BL2TS Ranges do not work properly?
If the surface units on your GE Ranges aren't working, first check your home's fuse box or circuit breaker and replace the fuse or reset the breaker if needed. Also, ensure the cooktop controls are correctly set for the specific surface unit you're trying to use.
What does 'F' and a number or letter flashing on my GE Ranges display mean?
If “F— and a number or letter” flash in the display of your GE Ranges, it indicates a function error code. Press the Cancel/Off pad, allow the oven to cool for one hour, and then put the oven back into operation. If the function code repeats, disconnect all power to the oven for at least 30 seconds and then reconnect power. If the function error code repeats, call for service.
How to fix GE JS760BL2TS oven light that does not work?
If the oven light in your GE Ranges isn't working, try these steps: first, check if the light bulb is loose or defective and tighten or replace it. Also, verify that the oven is not in Sabbath mode.
Why is there water remaining on oven floor after Steam Clean cycle of GE JS760BL2TS Ranges?
If you notice water remaining on the oven floor after the Steam Clean cycle in your GE Ranges, don't worry, this is normal. Remove any remaining water with a dry cloth or sponge.
What causes excessive smoking during the clean cycle on my GE JS760BL2TS Ranges?
If there is excessive smoking during the clean cycle of your GE Ranges, press the Cancel/Off pad and open the windows to rid the room of smoke. Wait until the LOCKED light goes off, then wipe up the excess soil and reset the clean cycle.
How to broil food properly in GE JS760BL2TS Ranges?
To broil food properly in your GE Ranges, ensure you select the appropriate broil mode and use the correct rack position. Make sure food is cooked in a cool pan specifically designed for broiling. If using aluminum foil on the broiling pan and grid, ensure it has been fitted properly and slit as recommended. In some areas the power (voltage) may be low, preheat the broil element for 10 minutes.
Why is there a strong odor coming from my GE Ranges?
A strong odor from the insulation inside the oven is normal for the first few uses of your GE Ranges. This is temporary and will go away after several uses or a self-clean cycle.
Why GE JS760BL2TS storage drawer won’t close?
If the storage drawer on your GE Ranges won’t close, the power cord may be obstructing the drawer in the lower back of the range; reposition the drawer and power cord. Alternatively, the drawer slide or rail may be improperly aligned with the support; reposition the drawer.
General| Brand | GE |
|---|---|
| Model | JS760BL2TS |
| Type | Slide-In |
| Fuel Type | Electric |
| Cooktop Surface | Ceramic Glass |
| Number of Burners | 5 |
| Oven Capacity | 5.3 cu. ft. |
| Self-Cleaning | Yes |
| Wi-Fi Connect | Yes |
| Convection | Yes |
| Width | 30 in. |
To Next Page
