34
OPERATING THE SELF-CLEANING OVEN
(continued)
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually a
salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE:
• No functions can be programmed before the door
automatically unlocks.
• If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
How to Set Delay Start of Cleaning
Delay Start is setting the oven to start the clean cycle
automatically at a later time than the present time
of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a
Clean Cycle section.
2. Press SELF CLEAN.
3. Press the INCREASE or
DECREASE pad to set the
clean time.
4. Press START TIME.
5. Press the INCREASE or
DECREASE pad to set the
time of day you want the clean
cycle to start.
6. Press START.
The door locks automatically.
The display shows the start time.
It will not be possible to open the
oven door until the temperature
drops below the lock temperature
and the LOCKED DOOR light
goes off.
7. When the LOCKED DOOR light
is off, open the door.
START
START
TIME
SELF
CLEAN
Easy Steps:
1. Press SELF CLEAN.
2. Press the INCREASE or DECREASE pad to
set the clean time.
3. Press START TIME.
4. Press the INCREASE or DECREASE pad to
set the start time.
5. Press START.
To Next Page
Loading...
Need help?
General
