Jation J
for 27" (68.6
n ui
On
For JKSI0, JKP30, JKP70, PK916, ZEK938 models only.
5" (12.7 era)
Max. from the
left or right
Cabinet _ side
--Width _
" 1
Cutout Width
25" (63.5 era)
Min. _"
25 1/4" (64.1
Max,
Junction Box
Location
/
Cutout
Height 22" (55.g era)
27 5/8" Min. above
(70.2 era) Min. base rail
28 1/8"
20" (50.8 cm)
- _7"
Allow
f" (2.5 era)
Allow a minimum
minimum for
of 20" (50.8 cm) for
clearance to adjacent overlap of
corners, drawers, oven top and
bottom
etc. when door is open of cutou_-_
Recommended
cutout location
from floor 32 1/2"
(82.6 era)
Alternate Junction
Box Location =
access from
adjacent cabinet
may be required
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
27" (68.6 cm)
32 1t2" (82.6 cm)
23 1/2"
(59.7 cm) Min.
25" (63.6 cm) Min.
26 1/4" (64.1 cm) Max.
27 5f8" (70.2 cm) Min.
28 1/8" (71.4 cm) Max.
w
NOTE: if the cabinet does not
have a front frame and the sides
are less than 3/4" (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
h
_fthe cabinet does not have a solid bottom,
two braces or runners must be installed
_evel with the bottom of the cutout to
support the weight of the oven. For
single ovens, the runners and braces
must support 150 tbs (68 Kg).
NOTE: _f marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
2"x4"(Scmx le c_) or
eqeivalent runners |eve|
with bettem ef cutout
T
24"
(61 cm)
1
/
I<- t8" (45.7 cm) "-_1
27" (68.6 cm)
These ovens are not approved for
stackable installations.
4
To Next Page
Loading...
Need help?
General
