CD
Replaceablecharcoalfilter
NOTE; DONOTrinse, or put charcoal filters in
an automatic dishwasher
Charcoal Filter--Recirculating Installations Only
The charcoal filter cannot be cleaned.
It must be replaced. Orderfilter no.
WBO2XI0700. Replacement filters
can be ordered fromyour GEsupplier.
If the hood is not vented to the
outside, tile air will be recirculated
through a disposable charcoal filter
that helps remove smoke and odm_.
The charcoal filter should be
replaced after 6 to 12 n_onths
(del)ending on hood usage).
Toremove:
Pull down on tile center ot tile fl'ont
edge of the filtei: The filter will then
slip out of tile retaining tabs on tile
back.
Toreplace:
Slip tile back edge ot tile filter into
the retaining tabs and push the
fl'ont edge up until it snaps into
place.
Stainless Steel Surfaces (on some models)
Do not usea steel-wool pad; it will
scratch the surface.
To clean tile stainless steel
S/llS[;ICe_ rise W}llIll sudsy water or
a stainless steel cleaner or polish.
_Mways wipe tile SUlti_ce in tile
direction of the grain. Follow the
cleaner instructions fi)r cleaning
the stainless steel sutthce,
To inquire about i)urchasing
stainless steel apl)liance cleaner or
polish, or to find the location of a
dealer nearest you, please call our
toll-fl'ee number:
NationalPartsCenter 800.626.2002
ge.com
Painted Surfaces (on some models)
Do not usesteel-wool pads or other
abrasive cleaners. They will scratch
the surface.
Clean grease-laden SUlti_ces ot tile
hood fl'equently. To clean tile hood
stwl;Ice, rise a hot, dam I) cloth with a
Inild detelgent suitable for painmd
S/lIl';Ices. Abo/It one tablespoon el
almnonia may be added to tile
wateI: Use a clean, hot, dam l)
cloth to relnove soap. Dia' with
a di N clean cloth.
NOTE:When cleaning, take care not
to c()me ill contact with filteI_ and
other non-enai/leled S/ll{;Ices.
CAUTION: When cleaning the
hood surfaces, be certab that you
do not touch the light bulb with moist
hands or cloth. A warm or hot light
bulb may break ff touched with a moist
surface. Always let the light bulb cool
completely before cleanbg around it.
Lightcover
Hood Light
CAUTION: i,et the light bulb cool
colnpletely beti)re remo;'ing. A
waIIn or hot bulb nlav break if
touched with a moist cloth or hand.
]_elnove tile bulb and replace with
an ordinal T sci'e_q)ase light bulb,
not more than60 watts.
Toremove the light cover
(on some models):
• Press tile sides with two fingeI_
until tile side I)rongs are released.
• i,ifl tile light cover and slide it
tow;IFd vet1 iI1 one lllotion.
Toreplace the light cover:
• Insert tile l)rong located at tile
end of tile cover into tile top
oI)ening.
• Gently push tile cover up and
press the sides to fit the side
prongs into the side openings.
• Release and the cover will lock
ill position.
5
To Next Page
Loading...
