14 KSA700 Series User Guide
Loop: [01] Zone: [01] Address: [001]
Type: Analogue value:
Zone:
Point:
History: Allows the operator to view the list of events that the system has recorded.
Navigate using the left / right keys on the keyboard.
Faults:
View current faults in the system.
Outputs: View the status of sounders and relays. Use Enter or to jump from one
output to the next.
Details available:
• If an output is enabled or disabled (ON/OFF).
• If an alarm event (event 1) has occurred.
• If an alarm event has occurred after a delay (event 2).
Relay Status Event 1 Event 2
1 ON 000 000
"
If the
Silence Alarms
or
Sounders Silence
key has been pressed before
checking outputs all sounders will be shown as OFF.
Disabled: Allows the operator to view zones and devices that have been disabled.
There are two options:
• Zones: to check disabled zones either partially or completely.
• Devices: to check disabled detectors across the installation.
Events:
View all events recorded by the system. Each event is identified with a number
(from 1 to 999).
To Next Page
Loading...