Installation instructions
iNSTALLiNG THE WATER LiNE (CONT.)
[-gqPLUG iN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the ref_igerator or against the
wall. Push the ref}igerator back to the wall.
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the ! (on}position. On feeler arm models,
move the feeler arm to the ON (down) position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F (-9°C) or
below. It will then begin operation automaficall>
FeelerArmin
the OR(down)position
NOTE: In lower water pressure conditions, the
water valve may ttun on up to 3 times to deliver
enough water to the icemaker.
REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
* Read the instructions all the way through before
starting.
* Handle parts carefully to avoid scratching paint.
* Set screws down by their related parts to avoid using
them in the wrong places.
* Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the binges f}om
the right side to the lef_ side--if you ever want to change
the binges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Maskingtape
3/8" Headsocketdriver
(a6-pointsocketis
recommended)
Puttyknifeor
thin-bladescrewdriver
T20or T25Torxce
driver,whicheveryour
modelrequires
14
To Next Page
Loading...
Need help?
General
