About the controls with temperature settin s.
(on some models)
[]
HoEd3 second_to r_set
TEMPERATURE SET
WARMER _ _WARMER
COLDER COLDER
oo_ Recom,_e,,d_d _7o FRecommended
[]
Hold 3 s_onds
[]
[]
Ho_d 3 seconds to re_t
TEMPERATURE SET
WARMER _ _WARMER
COLDER COLDER
0o_ Rec_,_e_ed 37° _ Recomme_ed
¢q
Hold3seconds
(FIGA) (on some models) (FIGB)
NOTE: Therefrigerator is shipped with protective film covering the temperature controls, if this film was not removed
during installation, remove it now.
The temperature controls are preset in the factory at 37°F for the refrigerator compartment and O°F for
the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature as well as the actual temperature in the
refrigerator and freezer. The actual temperature may vary slightly from the SET temperature based on
usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator compartments,
but does not shut off electrical power to the refrigerator.
Changing the Temperature
For Controls-on-the-Door Models:
FIG. "A" To change the temperature, press and release the
WARMER or COLDER pad. The ACTUAL TEMPlight will come on
and the display will show the actual temperature. To change the
temperature, tap either the WARMER or COLDER pad until the
desired temperature is displayed.
FIG. "B" To visualize the real temperature press and release
the ACTUAL TEMPpad. The display will show the actual
temperature for 10 seconds.
To change the temperature, tap either the WARMER or
COLDERpad until the desired temperature is displayed. The SET
TEMPlight will come on during this process.
For Controls Inside the Refr,_erator:
Opening the door displays the actual temperature. To change
the temperature, press either the WARMERor COLDERtouch
pads until the desired temperature is displayed.
Once the desired temperature has been set, the temperature
display will return to the actual refrigerator and freezer
temperatures after 5 seconds. Several adjustments may be
required.
Each time you adjust controls, allow 24 hours for the refrigerator
to reach the temperature you have set.
To turn the cooling system off, tap the WARMERpad for either
the refrigerator or the freezer until the display shows OFF. To
turn the unit back on, press the COLDERpad for either the
refrigerator or freezer. Then press the COLDERpad again and it
will go to the preset points of O°Ffor the freezer and 37°Ffor the
refrigerator. Setting either or both controls to OFFstops cooling
in both the freezer and refrigerator compartments, but does not
shut off electrical power to the refrigerator.
To Next Page
Loading...
Need help?
General
