Installation Instructions
[_]REPLACING THE REFRIGERATOR DOORS
(cont.)
r_ Insertthe top hinge pin into the hinge hole on top
of the refrigerator door. Makesure the door isaligned
with the cabinet and opposite door.Attach the hinge
to the top of the cabinet. Donot tighten bolts
completelg.
r_ on left-hand doors, passthe wires and water line
through the top hinge pin.Thenconnect the water line
and two connectors.
[] Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
[] Makesurethe gasket on the door is flush against
the cabinet and isnot folded. Makesure the door is
straight and the gap between the doors iseven across
the front. Whileholding the aligned door in place,
tighten the top hinge bolts.
r_ Reconnectthe two connectors at each side of the top
cap and reattach the three Phillips-headscrewson top.
F7]REMOVE THE FREEZER DOOR
r_ pullthe freezer door open to full extension.
FB] Removethe freezerbin bg pulling both brackets upward
at the same time. (Seepage 19.)
r_ Takeout the lower basket bU lifting the basket up from
the rail sgstem.(Seepage 19.)
r_ Removethe two 10 mm hex-head boltsfrom the right
and left side.
29
To Next Page
Loading...
