EasyManua.ls Logo

GE PGSS5PJXASS - Page 5

GE PGSS5PJXASS
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
About TurboCool.'"Ionsome models) ge.com
(on some models)
TURBOco_j
(onsomemodels)
How it Works
TurboCool rapidly cools the refrigerator
compartment in order to more quickly
coolfoods. UseTurboCool when adding a
large amount of food to the refrigerator
compartment, putting awag foods after theg
have been sitting out at room temperature or
when putting awag warm leftovers. It can
also be used if the refrigerator hasbeen
without power for an extended period.
Onceactivated, the compressor will turn on
immediately and the fans will cgcle on and
off at high speed as neededfor eight hours.
The compressor will continue to run until
the refrigerator compartment cools to
approximately 34°F(I°C),then it will cycle
on and off to maintain this setting. After 8
hours,or if TurboCool ispressedagain, the
refrigerator compartment will return to the
original setting.
How to Use
Press TurboCooL The refrigerator
temperature displag willshow bE.
After TurboCool is complete, the
refrigerator compartment willreturn
to the original setting.
NOTES: The refrigerator temperature cannot
be changed during TurboCooL
The freezer temperature is not
affected during TurboCooL
When opening the refrigerator door
during TurboCool, the fans will
continue to run if theg have
cgcled on,
About Door Alarm (onsome models)
The door alarm will sound if ang door is open
for morethan 2 minutes.The beeping stops
when gou close the door.
(on some models)
.i ooo ALARM i
(on some models)
Energg Saver
(on some models)
.[
(onsomemodels)
About Energy Saver (onsomemodels)
This product is equipped with an Energg
Saverfeature. The refrigerator isshippedwith
the EnerggSaverfeature enabled.
Overtime, moisture can form on the front
surface of the refrigerator cabinet and cause
rust. If moisture doesappear on the front
surface of the refrigerator cabinet, turn off
the EnerggSaverfeature bg pressing and
releasingthe ENERGYSAVERpad on the
control panel.

Related product manuals