Beforeyoucall for service...
Troubleshooting -tips
Save time and money! Review the chart on this page first
and you may not need to call for service.
Possible Causes What To Do
Warming drawer A fuse ha your home may * Replace tile fl/se or reset tile circuit breaker.
will notwork be blown or the circuit
breaker tripped.
Warming drawer not * Plu _ iu
plugged in.
Controls improperly set. * See the Using the warming drawer section.
Drawerdoes not Ball bearings out * Fully exteud the drawer aud push it all the way in.
slide smoothly of alignment. See the Care and cleaning section.
or drags Drawer over-loaded or * Redttce weight to less than 50 pottuds. Redistribt/te
load unbalanced, drawer contents.
Excessive Liquid in wm'mhlg * ReIuove liqtlid.
condensation drawer.
Uncovered foods. * Cover fi)od with lid or ahunintun foil.
Temperature setting * Reduce teu_l_eratttre setfiug.
too high.
Incorrect Moisture * Set the Moisture Selector to the ol)en vent setting to
Selector setting, allow venting.
No heat in the Room temperature * Ttu'n the knob to LOW theu back to PROOF
PROOFsetting may prevent the
thermostat from
tripping on.
Food dries out Moisture escaping. * Cover food with lid or altmfiutm/ foil.
/6
To Next Page
Loading...
