About the automaticicemaker (rant) GEAppliances.com
Models with tilt out ice bin
To access ice and reach the
icemaker power switch;
O Lift the bin, then pull it
forward until the bin stops,
O ower the bin to access ice
or reach the power switch.
Accessing Ice and Reaching
the Power Switch on Dispenser
Models
Thereare two types of ice storage bins
on dispenser models. One has a shelf above
the bin,the other does not.
Special note for models with tilt-out
ice bin:
Thesemodels have a tilt-out ice bin.
Thebin can be tilted out as shown in
the illustrations,and itwill hold itself
up while you take ice out or turn the
icemaker power switch on and off.
Besureto put the bin buck in place
beforeclosing the door.
NOTE."/n order to rake fiJ// adw_ntage of the d/t-
out ice bin, only store items on the shelf below
the ice bin that are no tzdler than the lowest
point on the bin.
Models with a shelf
above the ice bin
To access ice, puff the bin forward,
To reach the power switch, pull the
shelf straight out. AIw_ys be sure to
replace the shelf
On some models,
to access ice or reach
the po wer switch:
• , i!ii!il
|
O u// the bin fbrwz_fd until the
bin stops.
O ower the bin to access ice
or reach the power switch.
Removing Ice Bin (dispenser models)
CAUTION." Theice bin is heavy when full,
Setthe power switch to the OFFposition
before removing the bin.
When replacing the bin, be sure to press
it firmly into place. If it does not go all the way
back, remove it and rotate the drive
mechanism !/4 turn. Then pushthe bin
back again.
Hechanis
Dispenser Models only
15
To Next Page
Loading...
