About the automaticicemaker GEAppliances.com
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Theicemaker will produce seven cubes
per cycle-approximately 100-130 cubes
in a 24-hour period,depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the OFFposition.
When the refrigerator has been connected
to the water supply,set the power switch
to the ONposition.
Theicemaker will fillwith water when it cools
to !5°F (-10°C).A newly installedrefrigerator
may take 12to 24 hoursto begin making
icecubes.
Youwill hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice
to allow the water lineto clear.
Besure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the levelof the feeler
arm, the icemaker will stop producing ice.
It is normal for severalcubes to bejoined
together.
If ice isnot usedfrequently, old icecubes will
become cloudy, taste stale and shrink.
Special note about dispenser models:
Some models have a tilt-out ice bin.
Thebin can be tilted out as shown in the
illustrations,and it will hold itselfup while
you take ice out or turn the icemaker
power switch on and off. Besure to put the
bin back in place before closingthe door.
To restore your ice level from an empty
bucket stage, the following steps are
recommended:
O 12 hours after the first batch of icehas
fallen into the bin,dispense 3 to 4 cubes.
After an additional 6 hours, dispense
3 to 4 cubes again.
Thesestepswill restore your icelevel in
the shortest amount of time.
Power/"
Switch FeelerArm
(onsomemodels)
NOTE:
Power
Switch
X
cemaI<er
/
/
Green
Power Lign_ FeelerArm
(onsomemodels)
In homes with lower than average water pressure, you may hear the
icemaker cycle multiple times when making one batch of ice.
14
To Next Page
Loading...
