Why is the ice/water dispenser not working on my GE Profile TNX22P?
If the ice/water dispenser on your GE Refrigerator isn't working, check the electrical connections at the top hinge and inspect the water tube through the hinge for any pinching or binding.
Why does my GE Refrigerator motor operate for long periods?
If your GE Refrigerator's motor runs for extended periods, especially during the first day of use, allow 24 hours for stabilization. Also, ensure the condenser and grille are clean.
Why does the compressor fail to start in my GE Profile TNX22P Refrigerator?
If your GE Refrigerator's compressor fails to start, check the line voltage. If adequate, DIRECT START TEST: the compressor may be too hot, the line voltage too low, the relay malfunctioning, the overload inoperative, the refrigeration system restricted, the motor windings open or shorted, or the compressor mechanically stalled.
How to stop crushed ice dispenser from filling with cubes in GE Refrigerator?
To prevent the crushed ice dispenser in your GE Refrigerator from filling with cubes, reduce the fill time to prevent cubes from being too strongly joined together.
How to stop a rattling noise from the evaporator in my GE Profile TNX22P?
If you hear a rattling noise from the evaporator in your GE Refrigerator, apply slight pressure on the air duct cover. If the noise stops, disassemble the cover and ensure the wiring harness is clipped in place and not loose. Tightening the screws may also resolve the noise.
How to fix popping noise at fresh food door when closing of GE Profile TNX22P?
To address popping noise at the fresh food door when closing your GE Refrigerator, adjust the door so that the roller mechanism hits the pivot closure mechanism in the center by turning the hinge pin.
General| Brand | GE Profile |
|---|---|
| Model | TNX22P |
| Category | Refrigerator |
| Ice Maker | Yes |
| Energy Star Certified | Yes |
| Defrost Type | Frost-Free |
Advisory to disconnect electrical power before performing any service on the product to prevent injury.
Requirement to properly reattach all grounding wires, screws, straps, clips, nuts, or washers after service.
Warning and instructions to prevent tipping for models with door trim kits, requiring specific installation methods.
Technical data on electrical ratings, leakage, and energy consumption of the refrigerator.
Information on the refrigerating system, including compressor capacity, refrigerant type, and pressure.
Required clearances at the top, sides, and rear of the refrigerator for proper air circulation.
Details on the one-year and five-year warranty coverage for parts and labor, and what is not covered.
Instructions for setting and adjusting the fresh food and freezer temperature controls.
Instructions for reversing door hinges and associated hardware for changing door swing direction.
Detailed steps for replacing the evaporator, including heat shield and paste application.
Electrical schematic diagram illustrating the refrigerator's internal wiring and components.
Diagram showing the complete wiring connections for the refrigerator's electrical system.
To Next Page