GE PVX7360 - User Manual

Questions and Answers

M
Mr. Brian KnightSep 22, 2025
What to do if my GE PVX7360 Ventilation Hood fan is making noise and not circulating air well?
- M
  michaelhaynesSep 22, 2025
  If the GE Ventilation Hood fan is making loud or abnormal airflow noises, or if it seems to circulate air slower than usual, several factors could be at play. Start by checking for any obstructions blocking the vent. Ensure that the damper blade on the wall or roof cap swings freely and is in its original position. A dirty metal grease filter or charcoal filter (if present) can also cause these issues, so clean the metal grease filter and replace the charcoal filter. Finally, ensure sufficient makeup (replacement) air is available, as required by local building codes for exhausting appliances to operate correctly.
K
Kenneth FloresAug 23, 2025
Why is my GE Ventilation Hood making a loud noise?
- S
  Stephen DanielsAug 23, 2025
  If your GE Ventilation Hood is making loud or abnormal airflow noise, it might be due to the wrong duct size used during installation. Using a smaller duct pipe can reduce venting efficiency. Minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was installed improperly.
D
Devin BlevinsAug 25, 2025
How to fix a GE PVX7360 Ventilation Hood when the damper blade is not open?
- M
  Mrs. Monica WhiteAug 25, 2025
  The damper blade on your wall or roof cap might not be open. Make sure the damper swings freely and adjust it to its original position if the damper blades have flipped over, preventing it from fully opening.
M
Michelle VegaAug 26, 2025
What to do if the GE PVX7360 fan/light does not turn on?
- C
  Carrie HaasAug 27, 2025
  If the fan or light on your GE Ventilation Hood isn't working when you press the button, a house fuse may have blown, or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker to solve this issue.
L
Lisa VillaAug 27, 2025
Why does my GE Ventilation Hood need makeup air?
- P
  Peggy GarciaAug 27, 2025
  Insufficient makeup (replacement) air is required for exhausting appliances to operate to rating. Check with local building codes, which may require or strongly advise the use of makeup air. Visit GEAppliances.com for available makeup air solutions.
E
estephensSep 18, 2025
What causes early light failure in a GE PVX7360 Ventilation Hood?
- H
  howellashleySep 18, 2025
  If the light in your GE Ventilation Hood fails early, the light wattage might be too high. Replace it with a bulb of the correct wattage.
M
Michael HowardSep 15, 2025
How to fix a GE Ventilation Hood fan that doesn't operate when pressing the speed buttons?
- S
  sellersjeremySep 15, 2025
  If the fan on your GE Ventilation Hood doesn't work when you press the Lo, Med, or Hi buttons, the blower connector might be loose or not plugged in. Disconnect power to the unit, remove the filters, and check the blower. If the connector plug is loose or dangling, plug it in securely.
A
Angela HendricksSep 16, 2025
Why is my GE Ventilation Hood making loud airflow noise?
- M
  Melinda BrownSep 17, 2025
  Loud or abnormal airflow noise may be due to the wrong duct size used during installation. Using smaller duct pipe will cause reduced venting. It is important to minimize the duct run length and number of transitions and elbows. GE service technicians cannot correct this issue if installed improperly.
D
Devon HarrisonSep 6, 2025
Why is my GE PVX7360 so loud?
- M
  Michael WoodSep 6, 2025
  If your GE Ventilation Hood is making loud or abnormal airflow noises, it might be due to the wrong duct size being used during installation. Using a smaller duct pipe restricts venting. Try to minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was improperly installed.
S
Stuart GillSep 3, 2025
Why does my GE PVX7360 Ventilation Hood fan keep cycling on and off?
- D
  Dennis JonesSep 4, 2025
  If your GE Ventilation Hood fan is constantly turning off and on, it's likely that the motor is overheating. This can be harmful, so you should address it promptly. Clean the metal grease filter and replace the charcoal filter if one is present. Refer to the Care and Cleaning section of the manual for detailed instructions.