To Next PageTo Next PageHow to fix early light failure in GE Ventilation Hood?
To address early light failure in your GE Ventilation Hood, ensure that you are using the correct wattage bulb. Replace the light with one that has the appropriate wattage.
Why is my GE Ventilation Hood making a loud noise?
If your GE Ventilation Hood is making loud or abnormal airflow noise, it might be due to the wrong duct size used during installation. Using a smaller duct pipe can reduce venting efficiency. Minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was installed improperly.
How to fix a GE PVX7360 Ventilation Hood when the damper blade is not open?
The damper blade on your wall or roof cap might not be open. Make sure the damper swings freely and adjust it to its original position if the damper blades have flipped over, preventing it from fully opening.
What to do if the GE PVX7360 fan/light does not turn on?
If the fan or light on your GE Ventilation Hood isn't working when you press the button, a house fuse may have blown, or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker to solve this issue.
Why does my GE Ventilation Hood need makeup air?
Insufficient makeup (replacement) air is required for exhausting appliances to operate to rating. Check with local building codes, which may require or strongly advise the use of makeup air. Visit GEAppliances.com for available makeup air solutions.
What causes early light failure in a GE PVX7360 Ventilation Hood?
If the light in your GE Ventilation Hood fails early, the light wattage might be too high. Replace it with a bulb of the correct wattage.
How to fix a GE Ventilation Hood fan that doesn't operate when pressing the speed buttons?
If the fan on your GE Ventilation Hood doesn't work when you press the Lo, Med, or Hi buttons, the blower connector might be loose or not plugged in. Disconnect power to the unit, remove the filters, and check the blower. If the connector plug is loose or dangling, plug it in securely.
Why is my GE Ventilation Hood making loud airflow noise?
Loud or abnormal airflow noise may be due to the wrong duct size used during installation. Using smaller duct pipe will cause reduced venting. It is important to minimize the duct run length and number of transitions and elbows. GE service technicians cannot correct this issue if installed improperly.
Why is my GE PVX7360 so loud?
If your GE Ventilation Hood is making loud or abnormal airflow noises, it might be due to the wrong duct size being used during installation. Using a smaller duct pipe restricts venting. Try to minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was improperly installed.
Why does my GE PVX7360 Ventilation Hood fan keep cycling on and off?
If your GE Ventilation Hood fan is constantly turning off and on, it's likely that the motor is overheating. This can be harmful, so you should address it promptly. Clean the metal grease filter and replace the charcoal filter if one is present. Refer to the Care and Cleaning section of the manual for detailed instructions.
General| Lighting | LED |
|---|---|
| Color | Stainless Steel |
| Number of Bulbs | 2 |
| Filter Type | Baffle |
| Material | Stainless Steel |
| Width | 36 inches |
| Duct Size | 6 inches |
| Vent Type | Ducted |
