Before You Call For Service
Problem PossibleCause Whatto Do
Oven will not
start
A fuse in your home
may be blown or the
circuit breaker tripped.
Power surge.
Plug not fully inserted
into wall outlet.
Door not securely closed.
Floor of the oven is
warm, even when
the oven has not
been used
The cooktop light is
located below the oven
floor. When the light
is on, the heat it
produces may make the
oven floor get warm.
"LOC" appears The conwol has been
on display locked.
Vent fan will not The vent fro1
turn off automatically turns on
to cool hlternal parts
Mille the microwave
is on.
"BAD PROBE" The probe has not been
appears On display completely inserted into
the oven wall outlet.
The probe is defective.
"PLEASEINSERT Probe has been
PROBE" appears forgotten or not
on display inserted properly.
"SENSOR ERROR" When ushlg a Sensor
appears on display feature, the door was
couldopenedbe beforedetected,steam
Steam was not detected
in maxhntun mnotmt
of time.
36
• Replace tuse or reset circuit l>reaker.
• Unplug the IlIicrow_ive ovell, then plug
it l>a(k in.
• Make sm:e the 3-1)tong plug on the
oxen is tully inserted into wall outlet.
• ()t)ell the (toor and close seem:ely.
• This is nl)rmal.
• Press and hold CI]L_\R/OFF tot
abom 3 seconds to mflock tile coHtrol.
• The vent tbn (i4ll]l()| be [Hrl/e(I oil
while the microwave is ol)era6ng.
Tlfis is normal. Wait h)r tile microwave
to turn off mid tile tml will tidier go
off mltl)mati( ally or you will need to
turn it off l>} pressing die Vent Fan
pad after the mi( rowave is oil
hlseri |tie t)r/)l)e t)rol)erly in|o the
ovell wrall ()/ltlet.
• Ret)lace the t)robe.
• Insert the 1)rol>e 1)rot)erly into die
()xel/ wall ()H[leL
I)1) llOt /)t)en (toor /l]ltil ste_llll is
sel/se(1 _llld til//e is StlOWrl/ C/)Hlltil/g
down on disl)lay.
[lse Time Cook t() heat for more time.
To Next Page