25
Grounding Instructions The Problem Solver
PROBLEM POSSIBLE CAUSE
OVEN WILL NOT • A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
COME ON reset circuit breaker.
• Unplug your microwave oven, then plug it back in.
• Make sure 3-prong plug on oven is fully inserted into wall receptacle.
CONTROL PANEL • Door not securely closed.
LIGHTED, YET OVEN
• START pad must be touched after entering cooking selection.
WILL NOT START
• Another selection entered already in oven and CLEAR/OFF pad not touched to
cancel it.
• Make sure you have entered cooking time after touching MICRO COOK pad.
• CLEAR/OFF pad was touched accidentally. Reset cooking program and touch
START pad.
FLOOR OF THE OVEN • The cooktop lamp is located directly below the oven floor. When the lamp
IS WARM, EVEN is on, the heat it produces makes the oven floor get warm. This is normal.
WHEN THE OVEN
HAS NOT BEEN USED
All these things are normal with your microwave oven:
QUESTIONS?
USE THIS PROBLEM SOLVER
• Steam or vapor escaping from around the door.
• Light reflection around door or outer case.
• Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
• Dull thumping sound while oven is operating.
• Some TV-Radio interference might be noticed
while using your microwave oven. It’s similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
If you need more help...call, toll free: GE Answer Center
®
/ 800.626.2000 / consumer information service
To Next Page
Loading...
Need help?
General
