A
A& WARNING- POTENTIAL FIRE AND SHOCK HAZARD
• Use only rigid metal or flexible metal 4" diameter ductwork inside the dryer cabinet or for exhausting
to the outside. Use of plastic or other combustible ductwork can cause a fire. Foil or other easily
punctured ductwork can cause a fire if it collapses or becomes restricted in use or during installation.
• This appliance must be properly grounded and installed as described in these instructions.
Important
Exhausting the dryer to the outside is strongly
recommended to prevent large amounts of moisture
. and lint from being blown into the room.
• Service information and wiring diagram located in dryer
access panel.
ToolsRequired
Slip joint pliers
Phillips head and flat blade screwdrivers
Ratchet with 3/8" socket
Carpenter's level
Contents:
INSTALLATION
PROCEDURE - Page 2
PLUMBING
INFORMATION - Page 4
ELECTRICAL
INFORMATION - Page 5
EXHAUST
INFORMATION - Page 6
MOBILE HOME
INSTALLATION - Page 7
ALCOVE & CLOSET
INSTALLATION - Page 8
MISCELLANEOUS
REQUIREMENTS - Page 8
INSIDE
EXHAUSTING - Page 8
Product Dimensions
, 0
®
VENT
75 1,'2" _-_-
WATER INLETS
(REAR)
54 5/16"
DRAIN OUTLET
7
['_ - 3 314"
27"---- *
25 1/4" -_
*_'- 2 1/2"
11 7116"
To Next Page
Need help?
General
