Care
and Cleafing
(continued)
Light
bdb
replacement
In Fresh Food Compartment
1. Unplug refrigerator.
2. To align the control knob
properly, note position of
numbered control for proper
reassembly and pull off knob.
3. Pull bottom of light panel down
about
l/4’’—just
enough to
disengage lip at rear from grooves
in retainers on rear wall.
4. Lift panel to disengage top from
pins on side walls; remove panel.
After replacing with same size
bulb, reinstall panel (hang top on
pins; pull bottom down, push it
back and release it to let lip engage
grooves in retainers). Replace
temperature control knob in OFF
position, turn it to previous setting,
and plug refrigerator back in.
In Freezer Compartment
1. Unplug refrigerator.
H
After replacing with same size
bulb, reinstall shield and shelf and
plug refrigerator back in.
When you goon
vacation
For extended vacations or
absences, shut off power to
refrigerator, turn the numbered
control to OFF, clean interior with
baking soda solution of one
tablespoon of soda to one quart of
water. Wipe dry. To prevent odors,
leave open box of soda in
refrigerator. Leave doors open.
For shorter vacations, remove
perishable foods and leave controls
at regular settings. However, if
room temperature is expected to
drop below
60°F.,
follow same
instructions as for extended
vacations.
Move icemaker feeler arm to OFF
(up) position and be sure to shut
off water supply to the refrigerator.
When you move
Disconnect power cord from wall
outlet, remove all food and clean
and dry the interior.
Secure all loose items such as
grille, shelves and storage pans by
taping them securely in place to
prevent damage.
Be sure refrigerator stays in
upright position
during actual
moving and in van. Refrigerator
must be secured in van to prevent
movement. Protect outside of
refrigerator with blanket.
Water
filter
accessory
The perfect companion to
your automatic
icemaker—
a water filter
Your ice cubes can only
be as fresh-tasting as the
water that produces
them. That’s why it’s a
good idea to purify your
water with a water filter.
Its activated charcoal
removes musty, stale
odors and unpleasant
medicinal, metallic
tastes. A porous fiber
cartridge catches dirt,
rust particles, sand and
silt while special crystals
reduce deposits of
hard scale.
The water filter is an option at
extra cost and is available from
your GE dealer. Specify
WR97X0214.
It has complete
installation instructions and installs
in minutes on 1/4”
O.D.
copper
water line.
2. Remove shelf just below light
shield. (Shelf will be easier to
remove if it is emptied first.)
3. Pull plastic light shield toward
you. (It will bend to free tabs from
grooves.)
14
To Next Page
Loading...
Need help?
General
