How to fix a fan motor error on a GE Air Conditioner?
To address a fan motor error on your GE Air Conditioner, start by inspecting the DC fan motor wiring. If there's an error, correct or repair the wiring according to the wiring diagram. You might also need to replace the fan driver board. Additionally, check the CN8 port of the main PCB. If none of these steps work, consider replacing the fan motor.
What to do if my GE UUC130WCDA Air Conditioner has a high pressure error?
If your GE Air Conditioner displays a high pressure error, it might be due to excessive refrigerant. Inspect the outdoor unit coil and consider recharging it. Also, check for any restrictions within the refrigerant system. In some cases, replacing the PCB or the pressure switch may be necessary.
What to do if my GE UUC130WCDA Air Conditioner compressor is not operating?
If the compressor in your GE Air Conditioner isn't working, start by inspecting the wiring and ensuring it's receiving the correct voltage. If the wiring is good, the capacitor might need replacing. As a last resort, the compressor itself may need to be replaced.
What to do if my GE UUC130WCDA Air Conditioner fan motor is not operating?
If the fan motor in your GE Air Conditioner isn't running, begin by checking the wiring and verifying that it's getting the correct voltage. If the wiring is in order, the fan motor may need to be replaced.
What to do if my GE UUC130WCDA has a low pressure error?
If your GE Air Conditioner is showing a low pressure error, it could be due to a lack of refrigerant. Check the PCB and look for any leaks, then repair the leak and recharge the refrigerant. If that's not the issue, replacing the PCB or the pressure switch might be necessary.
What to do if the discharge temperature sensor is abnormal in my GE Air Conditioner?
If the discharge temperature sensor is abnormal in your GE Air Conditioner, first check the connection between the sensor and the PCB. If the sensor is closed, replace the PCB. If the sensor is open, replace the sensor.
General| Brand | GE |
|---|---|
| Model | UUC130WCDA |
| Type | Window Air Conditioner |
| Voltage | 115V |
| Fan Speeds | 3 |
| Control Type | Electronic |
| Filter Type | Washable |
| Installation Type | Window |
| Noise Level | 54 dB |
| Cooling Capacity | 13000 BTU |
| Room Size | Large |
| Features | Energy Saver Mode, Remote Control, Timer |
To Next Page
