(4D Stress Echo – cont.)
Template storage options
New template – initiate screen with blank template
Save as template – save template with a new name
Save template – save changes to template
Delete template – delete selected template
(cannot delete factory templates)
Scan Assist Pro
Scan Assist Pro
Using Scan Assist Pro
1. Select protocol
2. Select Category, select protocol
3. Scan Assist Pro will appear on bottom right of screen to begin protocol
4. Follow steps/commands located at bottom of image.
5. To move to next step, enter trigger button (image store or freeze
recommended). Trigger button must be configured in protocol template.
Note: all modes necessary will automatically activate when trigger is pressed
to move to next step of protocol
To Next Page
Loading...
