(2 Click Crop – cont.)
5. Press Layout button, another screen
layout can be chosen
6. Again press the 2 Click Crop button
from touch panel to Exit the tool
Note: Parallel crop is turned ON, since
2 Click Crop is using a parallel line
(2 Click Crop – cont.)
2. Press 2 Click Crop, set the 1st point on the position where you want
to start
3. Adjust the cursor to visualize the structure you want to see
4. Move the cursor to the final position and set the 2nd point
1st Click 2nd Click Adjust
4D Workflow Tools
To Next Page
Loading...
