(FlexiSlice – cont.)
While manipulating the 2D slices the rendered
image in the upper left corner will change and
depending on the 2D slice where the frame is
highlighted. The render image will be updated
accordingly.
Note: This tool is available during Live scanning
and post processing. This tool can also be used
to perform measurements on 2D slices or on
the 4D render image. The tool can be applied
on 4D images from 3V-D, 4V-D and 6VT-probe.
(FlexiSlice – cont.)
AFTER
The NEW 2D Slices belonging to the lines
Old and new position
of the lines
4D Workflow Tools
To Next Page
Loading...
