– 35 –
Diagnostics and Service Information
(Continued next page)
The washer control has a fi eld service mode that can be
utilized by the service technician in order to test critical
components and to access error codes. This fi eld service
mode will help the service technician to quickly identify failed
or improper operation of these components.
To enter the fi eld service mode, press and hold the START/
PAUSE button while rotating the Cycle Selector Knob 180° (8
detents on the control), then release the START/PAUSE button.
The fi eld service mode can be entered at any time. The
washer power does not have to be cycled before entering
service mode.
The starting position of the Cycle Selector Knob will not affect
entrance into the fi eld service mode.
Immediately following the release of the START/PAUSE button
all LED’s will activate. This is Knob Position “0 - Initial” on
the fi eld service mode chart. Rotating the Cycle Selector
Knob clockwise will result in the washer performing different
functions at each position as shown in the chart.
Field Service Mode
Entering the Field Service Mode
BEGIN
PRESS AND HOLD THE
START/PAUSE BUTTON
ROTATE THE CYCLE
SELECTOR KNOB 180
DEGREES
RELEASE THE START/
PAUSE BUTTON
FIELD SERVICE MODE
To Next Page
Loading...
