– 39 –
When excessive stop time more than 25-seconds is encountered, the LED blinks once for 1/4-second and •
then off for the remainder of a 6-second period.
When a broken coupling or slipping belt is detected, the LED blinks twice at a rate of 1/4-second on and •
1/4-second off for the remainder of a 6-second period.
When an inverter ROM checksum error is detected, the LED blinks 3 times at a rate of 1/4-second on and •
1/4-second off for the remainder of a 6-second period.
When a mode shifter error occurs, the LED blinks 4 times at a rate of 1/4-second on and 1/4-second off •
for the remainder of a 6-second period. The motor continues to operate with this error.
When a locked rotor is detected, the washer will sit idle for 15-seconds and retry. If the motor does •
not operate after 3 tries, the LED blinks 6 times at a rate of 1/4-second on and 1/4-second off for the
remainder of a 6-second period.
When a lid error is detected by the lid switch counter, 4 agitate/spin pairs with no change in state of •
lid switch, the LED blinks 7 times at a rate of 1/4-second on and 1/4-second off for the remainder of a
6-second period.
When an over-temperature condition is detected in the motor, the LED blinks 8 times at a rate of •
1/4-second on and 1/4-second off for the remainder of a 6-second period. The motor continues to
operate at reduced performance levels.
When a brake resistor circuit error is detected in the motor, the LED blinks 9 times at a rate of 1/4-second •
on and 1/4-second off for the remainder of a 6-second period. Maximum spin speed is limited to 50 RPM.
Critical Errors, #1, #2, & #7 as shown, will prevent inverter/motor from operating.•
To clear errors, disconnect power until an audible clicking sound is heard when the inverter capacitor
discharges (approximately 15-seconds). Open and close the lid 5 or more times in any 12-second period
within the fi rst 30-seconds of power-up. Errors will not clear if washer is in either agitate or spin mode.
Inverter/Motor Signal LED Errors
To Next Page
Loading...
