– 14 –
Demo Mode
In demo mode, the only components that will function are the control LEDs. No other components will
operate. The count down display will run much faster than normal.
Wash Cycle Defaults
When a cycle is initially set, the default cycle settings are displayed. The following table displays the default
selections for each cycle.
Note: Washer incorporates an adaptive fi ll algorithm which fi lls with only the amount of water to match the
load size.
To Enter Demo Mode To Exit Demo Mode
Unplug the washer.1.
Open the door.2.
Wait 30 seconds.3.
Restore power to washer.4.
Press 5. START/PAUSE 4 times within 30 seconds
of applying power.
Use same procedure as entering demo mode.
Note: Removing power from washer will not exit
demo mode.
To Next Page
Loading...
