– 53 –
Service Mode Test Sequence
t01 Version
Display
Enter Displays software version
Power Returns to service mode screen
t02 Error Codes Enter Displays error codes
Start/Pause Clears highlighted error code from washer
Power Returns to service mode screen
t03 User interface
test
Enter Turns all remaining LED on
Power Returns to service mode screen
Enter Display “U”
t04 Water valve
and dispenser
test
Soil Button On Turns on cold water valve and All Soil Level LEDs turn on
Soil Button Off Turns off cold water valve and All Soil Level LEDs turn off
Temp Button On Turns on hot water valve and All Temp LEDs turn on
Temp Button Off Turns off hot water valve and All Temp LEDs turn off
Spin Button On Turns on bleach valve and All Spin speed LEDs turn on
Spin Button Off Turns off bleach valve and All Spin speed LEDs turn off
Signal Button On Turns on bleach valve + cold valve together and signal LED turns on
Signal Button Off Turns off bleach valve + cold valve together and Signal LED turns
off
Power Returns to service mode screen
t05 Water level
sensor test
Enter Turns on the cold water valve, the water level frequency continue
updating on SSD
Power Drains and returns to service mode screen
t06 Drain Pump
test
Enter Turns on the drain pump
Power Returns to service mode screen
t07 Heater and
Thermistor
test
Enter On entry, the control will display the estimated temperature (0°F),
and turns on the cold valve and the heater is turned on.
The water temperature sensor test displays the water temperature
trend in the display. If the sensor is reading falling temperature
from the baseline it will blink the numbers in the display. If it senses
raising temperatures it will solid the numbers in the display.
Power Returns to service mode screen
t08 Tumble test Enter Unit tumbles
Power Returns to service mode screen
t09 Spin test Enter Displays “estimated” and “current” rpm
Power Returns to service mode screen
To Next Page
Loading...
