– 55 –
Error
Code
Description Action
3E4 IPM over
heating
error
Check integrity of the main PCB. Replace if necessary.•
tE Water
thermistor
error
Check integrity of the thermistor. Replace if necessary.•
dE Door open error The door is not closed.•
- Please close the door again as the washer will not function correctly when •
the door is left open.
Check the door DC switch. Replace if necessary.•
dE1 Door lock error The door is not closed.•
- Please close the door again as the washer will not function correctly when •
the door is left open.
If the fault persists and re-appears, replace the door lock switch.•
dE3 Door unlock
error
The door is not closed.•
- Please close the door again as the washer will not function correctly when •
the door is left open.
If the fault persists and re-appears, replace the door lock switch.•
If the fault persists and re-appears, replace the main PCB.•
bE2 Button error Check button operation.•
If the fault persists and re-appears, replace the sub PCB.•
AE Communication
error between
Main and Sub
PBA
Check the integrity of the wiring between the main PCB and sub PCB.•
Clear the fault and run the cycle. If fault persists and reappears, replace the •
main PCB.
SF System Failure
error
Replace the main PBA.•
DE2 Door Protection This occurs if power to the door circuit is on and off continually and •
excessive heat is generated.
UE Out of Balance
Error
Washer was unsuccessful in recovering from an out of balance condition •
during the fi nal spin and 34 minutes was added to the cycle timer.
NOTE: It’s important to note error codes should only be used to help identify those components which
require testing. Never replace a part based solely on an error code. The control can generate a false error
if the right conditions exist. Use the code only as a reference and always check the component before
replacing.
To Next Page
Loading...
