Installation Instructions
INSTALLING THE WASHER (cont.)
7. Attach lJ-shaI)ed hose guide to the end of the drain
hose. Place the hose in a laundry tub or standpipe
and secure it with the cable tie provided in the
enclosure package.
NOTE: If the drain hose is placed in a standpipe
without finming a U shape, a siphoning action could
occm: There m fist be an air gap arotmd the drain hose.
A snug hose fit can also cause a siphoning action.
CableTie/
CableTie71
CableTie
8°
Plug the power cord into a grounded outlet.
NOTE: Check to be sure the power is off at a
circuit breaker/fllse box befl)re plugging the power
cord into }Ill outlet.
9. Tm'n on the power at a circuit breaker/fllse box.
10. Read the rest of this Owner's Manual. It contains
valuable and hell)tiff information that will save wm
time and Illonev,
11. Before starting the washer, check to make sure:
Main power is turned on.
U_IThe washer is plugged in.
F_IThe water fimcets are tin'ned on.
U_lThe refit is level.
The shil)ping support hardware is removed
and saved.
The drain hose is properly tied up.
There are no leaks at the timcet, drain line
or washen
12. Run the washer through a complete cycle. Check
fi_r water leaks and proper operation.
13. If wmr washer does not operate, please review
tile Before You Call For Service section before
calling fin" service.
14. Place these instructions in a location near the
washer fin" flmue refl_rence.
REPLACEMENT PARTS
If replacement parts are needed fi:,r your washe_; they
can be ordered in the United States by visiting our
_4'ebsite at ge.com or by calling 800.GE.CARES.
17
To Next Page
Loading...
