About the washer features.
NOTE: Features may not be a vailable on all washer models.
Cycle Signal
SIGNAL'
ge.com
Use the SIGNAL button to change the
;ohune of the end of cycle signal.
Press the button until you reach the
desired _olmne.
Prewash
Prewash is an extra wash before the
main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-eflidency
detergent, or the proper wash additive
to the prewash dispenser
NOTE:Whenselectingprewash,it is
recommendedto usepowderdetergentin the
mainwash(detergent)compartment.
0 EXTFIA
RINSE
Extra Rinse
Use an extra rinse when additional
rinsing is desired to remo_e excess dirt
and detergent from soiled loads.
®
Delay Start
You can delay the start of a wash cycle
i for up to 12 hom_. Press the DELAY
STARTbutton to choose the number of
hom_ you want to delay the start of the
c)'cle, then press the STARTbutton. The
machine will cotmt down and strut
automaticallv at the correct tim e.
NOTE: If you forget to fully close the door, a
reminder sl#nal will beep remlbding you to do
SO.
NOTE:If youopenthe doorwhenthe delayis
countingdown,themachinewill enterthe
pausestate. Youmustc/osethe doorand
pressSTARTagainin orderto restartthe
countdown.
Lock
You can lock the controls to prevent any
selections fl'om being made. Or you can
lock the controls after w)u have started a
cycle.
Childrencannotaccidentallystart the washer
bytouchingpadswith this optionselected
To lock the washe_; press and hold the
lock button for 3 seconds. To tmlock
the washer controls, press and hold the
lock button for 3 seconds.
The control lock icon on the display will
light up when it is on.
NOTE:ThePOWERbuttoncanstill beused
whenthe machineislocked
d)
HOLD3 SEC
ro
MY CYCLE
To save a flaw)rite c)'cle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds. A beep will sotmd
to indicate the cycle has been saved,
To use xour custom c_cle press the MY
CYCLEbutton belore washing a load.
To chanoe the saved cycle set the
desired settings and heM down the MY
CgCLEbutton tot 3 seconds.
NOTE:WhenusingMY CYCLE,wash
optionscannotbemodifiedafter thecycle
hasbeenstarted
NOTE:If youchangewashoptionswithMY
CYCLEbeforestarting thecycle,theMY
CYCLEh_htwi// turn off andyouwi// be
returnedto thebasecycle.
To Next Page
Loading...
